Sections of checking are pressure tank, piping, pumps, safety valve, level gauge, pressure gauge, pressure switch.

It should be renewed and/or repaired in case that are malfunction or damaged of level gauge, pressure gauge, pressure switch, etc.

Regular open pressure tank drain valve, start pump flush water tanks or open the
compressed air blowing wash water tanks.

Disassemble the tank to clean, and get rid of the filth, then brush it by water. If the paint on the tank surface has peeled off, repaint it. Paint the anticorrosive paint again and change the accessories. Do not install the components until they are dry.

Pay attention to the temperature rise between motor and bearing and the leakage of mechanical sealing. If abnormal situations are found, check reasons.

Hydrophore pump mechanical seal can start slight dripping during operation. Visual leakage check should, however, be carried out from time to time in order to forestall full failure and ensure in-time exchange any seal.

Check frequently seal of contact and faucet on the inhalational pipelines to avoid air coming and keep the pump running normally.

 

Last modified: Thursday, 9 March 2023, 5:52 PM